The Planted Tank Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1,374 Posts
Discussion Starter · #1 ·
My xp2 just died found standing water on my floor. It seems to be leaking water from power cord. I didn't realize the new ones still had this problem.
This pump was also running my cerges reactor. I also have a eheim 2217 running but it's not same pipe diameter to run the reactor.

I was wondering if anyone had any pump recommendations I can get to run my reactor or if I should get new barb fittings and plug the 2217 into it
 

·
Registered
Joined
·
1,374 Posts
Discussion Starter · #2 ·
So after looking around online some people say water coming from power cord is caused by the quick disconnect not seated properly. I took the motor head apart dried it lubed orings and gonna see if leaks.
 
1 - 2 of 2 Posts
Top