The Planted Tank Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
715 Posts
Discussion Starter · #1 ·
So I managed to bend the little brass piece that slides over the vinyl CO2 tubing, and when I went to grab a replacement there is ones for nylon or steel lines.

Which do I get? The nylon one is $6 and the steel line one is only like a $1.

Whats the difference?

Thanks in advance.
 

·
Registered
Joined
·
715 Posts
Discussion Starter · #3 ·
Its a paintball setup, and im talking bout where the co2 line goes into the needle valve right after the asa valve.

I found a new brass one and it did the same thing. It turns sideways as i tighten down the nut and crushes it and part of the line too. might test it for leaks as is.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top