The Planted Tank Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
146 Posts
Discussion Starter · #1 ·
Are all solenoid valves compatible with all pH controllers?

I am using the entire Milwaukee setup, regulator, solenoid and pH controller, but it seems my solenoid has just failed. I noticed my drop checker is in the yellow, I checked and CO2 is still injected, the pH controller says the pH is 5.9it is set to turn off at 6.2. CO2 is still bubbling in the bubble counter, even if I unplug the solenoid, and I cant hear the click it usually makes when it turns on and off.

I would like to get a better solenoid and/or regualtor but was concerned that another brand of solenoid may not be electrically compatible with my pH controller.

Thanks!

Edit: Nevermind I'm just ordering another Milwaukee.
 

·
Registered
Joined
·
1,185 Posts
As long as the voltage and plug shape are correct for the US, they should be compatible. The only problem is, I have looked for just a solenoid and found that for the cost of one you can get a whole regulator setup that is already assembled and ready to use.

PS- Sorry, I just noticed that you already figured this out by your edit.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top