The Planted Tank Forum banner
1 - 1 of 1 Posts

322 Posts
Discussion Starter · #1 ·
Any old school RexGrigg style reactor users out there? Looking to see how far up from bottom you put plastic biob balls to break up the co2. Something happened to mine form last use until now where the CO2 cannot seem to get in. Checked brass fitting, checked flow check and everything. The CO2 setup is in use with a diffuser with no issues. Just wondering if I had to many bio balls in it and was causing pressure?

I am going to increase barb fittings to 1" to accommodate my FX6 tubing, reduce the bio ball count and try again. Just looking for some thoughts. Thanks!


1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.