The Planted Tank Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
117 Posts
Discussion Starter · #1 ·
Hi guys, I have a rex griggs (diy) and I am thinking of making a bypass. I have a ball valve front and back, and have back 1 turned about 1/2 way to avoid gurging. This all is powered by a sun sun 703, which has become very noisy. I am wondering if the bypass will help with the gurgling and noise from the filter.

The r.g. is 2" x 24".

What size should the by pass pipe be?

thanx
richard
1030195
 

·
Registered
Joined
·
117 Posts
Discussion Starter · #3 ·
I was gonna use the valve from the bottom. The 1 on top i close when I shut off the pump to keep the tubes full of water and ready for priming as I find that filter a pain to get going again.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top