The Planted Tank Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
197 Posts
Discussion Starter · #1 ·
Tried to use 2213 on my 40B but the flow rate looks a bit too low. I have a new XP3 standing by. Will the flow rate be too high if I use XP3 on 40B? Heavily planted tank with CO2.

Thank you!
 

·
Registered
Joined
·
529 Posts
I don't think it will be too high for you. I used an XP3 on my 50B (same footprint as 40 breeder, but taller). I ended up using the spray bar along the left side instead of along the back or using the jet outflow.
 

·
Registered
Joined
·
30 Posts
I've been using a xp3 on my 40g breeder planted tank for about 2 years now, no problems at all. There is a valve you get with it as well if you want to slow down the flow rate, it fits onto the outtake part.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top