The Planted Tank Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
Ok I bought the Red sea co2 pro system and set it up a few days ago.

Co2 Levels, PH and all other levels are all good.

The reactor however is spitting quite a few bubbles out at 20 second or so intervals. ( Big burst of quite a few bubbles then normal behaviour. )

If I lower the needle valve it just makes the interval a little longer.I tried adjusting the Reactors controls too to no avail.I also tried taking reactor out of water and making sure everything was connected right which it seems to be.

Anyone got any ideas???
 

·
Registered
Joined
·
7 Posts
Discussion Starter · #3 ·
No kinks or pinches.

If I turn the needle valve way down and crank the Co2 reactor switch to full it goes away.This is at about 0.75 bubble a second in the bubble counter.

The only problem with turning it down this low is I don't believe I am getting adeqaute Co2.
 

·
Registered
Joined
·
7 Posts
Discussion Starter · #4 ·
After rechecking problem it is still occuring at lower pressures.

Is it possible to just use a different reactor??? ( Maybe bigger )
 
1 - 4 of 4 Posts
Top