The Planted Tank Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter · #1 ·
I just started using my pressurized system today & last nite i put the co2 monitor supplied with it in tank & it shows Green= suff level of co2..?? without ever turning co2 on?? what gives.. it sat for 24hrs in tank & still no change so right now im running it at 1bar,1 drop per sec in bubble counter into the reactor 500 on low any suggestions. i got a super water test kit from redsea with every test immaginable . going to use the c02 test in it tomorrow after co2 turns on for couple hours:help: my 55 gal tank is being filtered by a fluval 405 & 2 aquaclear 30 pwrheads with quick filters so i know i have ample water flow & o2 also co2 comes on with my coralife lights 4x65 6700k cpf in 8 hr cycle please tell me what i should change.. Rexx help a brother out? P.S. luke is a douche
 

·
Registered
Joined
·
644 Posts
What is the KH of the water in your drop checker? You need to set your KH to 5 degrees or higher for the drop checker to be accurate according to Red Sea.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top