The Planted Tank Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
174 Posts
Discussion Starter · #1 ·
I've been pouring over retail sites and forums and I've seen conflicting comments comparing the Eheim 2211 vs 2213. I was hoping someone here with experience with them can help.

My main questions:
1. Does the 2211 come with doubletap connectors? I keep finding conflicting comments about this.

2. Would the 2211 have enough flow/power to use an in-line heater?

3. Would the 2213 be way too much for a 7 gallon 12" cube? Would using a valve on the return hose to limit the flow rate cause additional strain or wear to the pump?

Any advice would be appreciated. Thanks!
 

· Banned
Joined
·
1,866 Posts
I have three 2211s. All came with double tap connections. Not sure about in line heater. A valve to limit output will not hurt either one because there both magnetic impeller pumps.

Sent from my XT1585 using Tapatalk
 

· Registered
Joined
·
174 Posts
Discussion Starter · #4 ·
Thanks for the replies. Glad to hear the 2211 come with the doubletaps.

That's a nice looking scape shaman! I'm planning on doing a DIY inline heater as well so it's good to see one in use.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top