NWA's oddly shaped nano.... From scratch 07/22/13 update

Yay! You did decide to put pictures up with this! It looks great so far! When I rebuilt my 25 gallon tank, I had to tear it back down like that. A few helpful hints I learned along the way.

1. A helper to position and hold things is indispensable. Even if all they do it keep it square while the next piece goes on, so worth while.

2. Before siliconing, put all the hold it together bits of tape on all the bits of glass. This is probably common sense, but makes it easy to get it all together. When I did my taping, I did some from the bottom piece onto the side pieces as well, to help keep it all centered while it dried. It may have been redundant, but it made it go nice and smoothly.

3. Wet paper towels. Seriously. 3 of them on a plate ready to go. You WILL get all sticky and you don't want to leave finger prints in the middle of your front pane.

4. Straight seams can be achieved without tape. If you think you can hold a steady, even, quick pressure, then it's not worth doing, and a whole lot more effort to take apart.

5. Pick which pieces you want to be front and back. Theoretically, there should be no scratches on them at this point. Check anyway, mark with a sharpie. The last thing you want to do is guess when it comes to putting it together.

These all seem like stupid, common sense things. Until you have silicone all over your elbow and keep sticking it on your panes of glass and cursing.

Well I ended up doing lines of silicone on the base piece then setting/ rolling onto the beads to make sure it has silicone between the panes, all of the sides look good, no bubbles. I tried doing it this way to keep from having to much silicone on the inside of the tank (some areas will still need to be trimmed but hey! it should hold water, any silicone that squished out got finger smoothed back against the joint, just to make sure


Extra tape


Oh and 15 gallons of wine going haha

And Frank before you ask, I did not drink before hand

Siliconed up


The edges






This was actually pretty fun and relatively easy. I think I may have started something with myself here, all the silicone squished out on the outside will be shaved off.

Woot! silicone fumes wweeee
Sent from my SCH-I535 using Tapatalk 2