The Planted Tank Forum banner

Moss Squares

714 Views 7 Replies 6 Participants Last post by  diwu13
I want to make squares of moss, quite a few of them. How would I go about getting the moss to stick to needlepoint mesh or something like it? I tried super glue and it was a mess. I dont want to make 100 little pouches, unless someone has a good way to do that quickly :O
1 - 8 of 8 Posts
Ever tried stainless steel mesh and lace mesh?
I want to make squares of moss, quite a few of them. How would I go about getting the moss to stick to needlepoint mesh or something like it? I tried super glue and it was a mess. I dont want to make 100 little pouches, unless someone has a good way to do that quickly :O
Sewing thread........and just tie it around the moss.
Needle point mesh floats. I found that out after spending the whole afternoon attaching moss then trying to wedge it to the floor!
Needle point mesh floats. I found that out after spending the whole afternoon attaching moss then trying to wedge it to the floor!
I suction cup them to my tank walls ;D

SS mesh would be the best for sinking ones for sure.
Where could one get their hands on some SS mesh?
Where could one get their hands on some SS mesh?
i believe that H4n sells it. hit him up
I use SS mesh + walmart cloth mesh on top. I find for some mosses just wrapping the square of SS mesh in fishing line doesn't work that well. This is especially the case if you rip the moss up very fine, in which case netting is better.
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top