The Planted Tank Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
658 Posts
Discussion Starter · #1 ·
I have a Magnum HOT that I only use for vaccuming on occasion. It's been a while since I've used it, but now it doesn't work right. It starts out with great suction, but after 10 minutes or so it trickles to nothing. The water level in the canister never decreases. It does this with the hard intake attached, or the gravel vaccuum with the micron filter, and the sleeve (with no carbon inside). It's assembled correctly according to the manual, and the o-rings are new. The cover d-ring also looks good. I've taken it completely apart several times but no luck. I'm stumped.. anyone else run into this? Thanks
 

·
Registered
Joined
·
658 Posts
Discussion Starter · #3 ·
I thought that might be the case, but the same thing happens with an empty sleeve inside instead of the micron.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top