The Planted Tank Forum banner

Is brass dangerous to lifestock?

1162 Views 3 Replies 4 Participants Last post by  OlWolf
I just realized I may have done something stupid...

I have a 5 gallon glass beverage dispenser with a brass spigot. Inside the jar is a 1/2" brass nut that secures the spigot to the jar. Also in the jar are approximately 7 shrimp, a lot of plants, and about 2" of Eco Complete.

Is the brass a danger to the shrimp or the plants? Is there something like aquarium sealant that I could use to cover the metal part? What I'd like is to make a blob (think used chewing gum) to seal off the metal from the tank, but I'm not sure it would stick under water. Will I have to drain and dry the jar?

Any suggestions would be much appreciated!
1 - 1 of 1 Posts

· Registered
701 Posts
Water is an electrolyte. In order for corrosion to occur you need an electrolyte, a metallic pathway (in this case it will be the metal it self) and an anodic spot and cathodic spot (again in this case it will be parts of the same metal structure). In order to stop the corrosion you would need to eliminate one of the four conditions. Sealing the brass with silicon could eliminate the corrosion. But in the industry there is the old adage that there is no perfect coating. Anywhere the brass is not sealed it will create what is called a pinhole and in these areas corrosion is accelerated.

Brass is a rather stable metal (the reason it is used in many fittings)

That being said there is a reason that all water conditioners on the market work against heavy metals. I would get it outta there.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.