The Planted Tank Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
I am currently in the need of some major help with my pressurized co2 system. I have been using a paintball setup to pump co2 in my tank, but I recently came across a nice 5# vessel for a good price. My regulator is designed for the paintball canisters, and when I put it on the 5# tank it leaks. Obviosly dosent fit the CGA 320 fitting. Is there an adapter that would go from 320 to paintball canister, to my regulator? Please help, I am to the point where I am going to buy a new regulator, but I dont want to miss out on a cheap fix.
 

·
Registered
Joined
·
751 Posts
I think you just need a new CGA 320 inet and nut, if your regulator allows replacement. What regulator do you currently have?
 

·
Registered
Joined
·
1,227 Posts
If you're regulator consists of a simple ASA on/off valve, then you just need to ditch it, and get an actual regulator. If you have an actual regulator that was made for paintball kits, then you need to replace your regulator. If you have a normal regulator that is just adapted to the paintball, likely all you need to do is remove your paintball adapter. Please include a picture of this so we can help you.
 
1 - 3 of 3 Posts
Top