The Planted Tank Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter · #1 ·
1- Get an injector of any size desired. I prefer 10 and 20 mls.


2- Cut the back side of the injector's inner piece. Keep the round shaped piece and throw the rest.


3- Glue the round shaped plastic piece to the bottom of the injector in order to fill in the hole. I prefer to stick them together by hot PVC because it is a rapid sticker.


4- Then, make a hole on the bottom where you can fit an air pipe joint.


5- Take two plastic suckers that are big enough to fit the injectors.


6- Slip the suckers on the injector. Your bubble counter is ready.


7- Connect the counter to the CO2 systems.
 
1 - 3 of 3 Posts
Top