The Planted Tank Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
976 Posts
Discussion Starter · #1 · (Edited)
I know this used to be a topic a while back, but I would appreciate your insight. I am not looking to create a reactor, this is for a 300 litter tank, for the rest of us an 80 gallon tank.
I am trying to find out what is the best PSI (not volume) to most efficiently run a glass diffuser as in the pictures below.

1027653
1027654
1027655
 

·
Registered
Joined
·
13,078 Posts
Generally around 35psi.
Note some disks need a pre-soak before using..

You could use the Milwaukee way of figuring out the sweet spot.
Generally open the metering valve full and slowly (and w/ a lag) increase pressure until you get bubbles, then decrease needle.
Not often done this way..
 
  • Like
Reactions: fplata

·
Registered
Joined
·
976 Posts
Discussion Starter · #3 ·
Generally around 35psi.
Note some disks need a pre-soak before using..

You could use the Milwaukee way of figuring out the sweet spot.
Generally open the metering valve full and slowly (and w/ a lag) increase pressure until you get bubbles, then decrease needle.
Not often done this way..
Thank you! This is exactly what I was looking for
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top