The Planted Tank Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
198 Posts
Discussion Starter · #1 ·
I'm going to be hooking up my new Azoo regulator onto my 20lb tank. This is the first time I've used it. I have the smaller paint ball style tank. On the paintball tank I have to turn it "on" until the pressure reads between 10-20psi. With the big tank do I do the same thing? How much psi should I run? Do I open the tank valve slowly? All the way? The directions dont say what I should set it at. Just not in the red zone...but there are no red zones on the regulator. Thanks guys!
 

·
Super Moderator
Joined
·
12,126 Posts
In general, most people aim for anywhere from between 10-30 PSI of working pressure.

When you are opening the CO2 tank, open it slowly. You do not need to open it all the way (usually, a half turn is more than enough to register some pressure on the high pressure gauge).
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top