The Planted Tank Forum banner
1 - 1 of 1 Posts

651 Posts
Discussion Starter · #1 ·
Hi all. I was wondering if anyone here has used a 3d printer to print moss mesh before.

I'm working with a small acrylic tank (1.5G EcoQube c). The opening on top is relatively small, and the back wall is irregularly shaped.

I was thinking it would be cool to have a custom-printed moss mesh to go into the back corners, and wrap around the back, giving me a flame moss curtain around the back wall.

Has anyone done that? Or do you know of a place that you can just order a couple of small printed pieces from?

Of course, I could probably end up with the same effect by clamping moss between two chopsticks or bamboo skewers.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.