The Planted Tank Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-4 of 11 Results
  1. Equipment
    I probably would buy a kit next time, piecing this together was a chore... I keep the output ~5psi, which is the only way I could get anything less than "a lot" of bubbles per second. I'm putting CO2 into a reactor, so I don't need the higher psi (like you would need for a diffuser). Please...
  2. Equipment
    Linde REDLINE Regulator: R200/2-8SS Hi everyone! I wanted to share my DIY dual stage regulator build. Parts List in order of installation: 5 LB. Aluminum CO2 Cylinder CGA 320 Nut/Nipple Linde REDLINE Regulator: R200/2-8SS Stainless Steel Swagelok Pipe Fitting, Hex Long Nipple, 1/4 in. Male...
  3. Equipment
    Hey guys, I am building my custom CO2 regulator and looking around for parts. I am lucky enough to have a Swagelok distributor in town (gotta love Portland, Oregon!) and, since I wont have to pay any shipping costs, looking very closely at their needle valves. It sure aint easy trying to...
  4. Equipment
    I recently acquired a Matheson 3810 stainless regulator, however it does not have a low pressure gauge and I need to switch out the stem on it (cga 580) to a cga 320. Where is the best place to obtain a low pressure gauge that is a 316 stainless Matheson gauge with a range from preferably...
1-4 of 11 Results
Top