Cerges reactor question
Planted Tank Forums
Your Tanks Image Hosting *Tank Tracker * Plant Profiles Fish Profiles Planted Tank Guide Photo Gallery Articles

Go Back   The Planted Tank Forum > Specific Aspects of a Planted Tank > DIY


Reply
 
Thread Tools Display Modes
Old 10-25-2012, 12:49 PM   #1
5BodyBlade
Planted Tank Obsessed
 
5BodyBlade's Avatar
 
PTrader: (2/100%)
Join Date: Feb 2011
Location: Westport, MA
Posts: 364
Default

Cerges reactor question


I've been using my newly built cerges reactor for a few weeks now and I'm still wondering:
A) Why is my drop checker only reaching green/blue when I'm running a lot of bubbles per second? It's pretty much a constant stream of bubbles.
B) Why does it take so many more BPS than a normal diffuser or Rex Grigg reactor even?
I realize that with a diffuser the bubbles are filling the water column and getting into the bell causing the drop checker to get a higher reading faster. And that a drop checker is only a very rough estimate of CO2 levels, but it's all I got. What is the better situation for growth, a yellow/green drop checker with 3 BPS from a diffuser or a blue/green drop checker with 7-8 BPS from a cerges reactor?
I really like the cerges reactor because of the no bubble look and having less equipment in the tank, but I'm starting to wonder if I am using the best method.
__________________
http://www.plantedtank.net/forums/sh...49#post4205849

40B, T5HO, Turface, pressurized co2,EI dosing
5BodyBlade is offline   Reply With Quote Quick reply to this message
Sponsored Links
Advertisement
 
Old 10-25-2012, 10:17 PM   #2
jstehman
Planted Tank Obsessed
 
jstehman's Avatar
 
PTrader: (2/100%)
Join Date: Dec 2010
Location: LaVista, NE
Posts: 449
Default

Did you try tilting the reactor a little like 20 degrees or so? Then the output flow from your canister/pump will blast into the gas pocket that collects at the top.
__________________
Never show anyone your true potential. If you do, they will always expect it.
jstehman is offline   Reply With Quote Quick reply to this message
Old 10-26-2012, 12:03 AM   #3
brogan
Algae Grower
 
PTrader: (1/100%)
Join Date: Jan 2012
Location: Downers Grove
Posts: 100
Default

Unless you have a leak somewhere, the Cerges is more efficient. Especially if you do not see any micro bubbles out of you outflow pipe. If you don't see micro bubbles you are getting 100 percent dissolution of CO2.

You're drop checker was probably giving you false readings with your old diffuser pushing CO2 into bubbles into it.

Double check for leaks, Then watch your plants for increased growth.
brogan is offline   Reply With Quote Quick reply to this message
Old 10-26-2012, 05:46 AM   #4
inkslinger
Wannabe Guru
 
PTrader: (1/100%)
Join Date: Dec 2003
Location: Taunton ,MA
Posts: 1,694
Default

Tank size,type filter used and what size house filter did you set-up ? I use a 20" x 4.5" house filter with a Eheim 2262 filter for my 110g tank and it works great . I fill my reactor with mini bio balls to break up co2 and the flow and I get 100% diffusion.
inkslinger is offline   Reply With Quote Quick reply to this message
Old 10-26-2012, 10:39 PM   #5
5BodyBlade
Planted Tank Obsessed
 
5BodyBlade's Avatar
 
PTrader: (2/100%)
Join Date: Feb 2011
Location: Westport, MA
Posts: 364
Default

I've tried tilting the reactor and there's no change. I don't hear any gurgling from it like if there was a gas pocket.

I'm not getting any micro bubbles from the output. I sprayed soapy water on all the connections...no leaks.

It's a 40 breeder, Aquatop 500 filter, I used the normal normal size filter housing not the 20" and I put a coarse sponge in the bottom. Like I said no bubbles escaping the reactor.

This is really frustrating be cause the bubble counter is pretty much a constant stream of bubbles and I've put new 4dkh in the checker and still getting the same reading. Unfortunately I can't judge anything by plant growth as of right now as this is a new setup.
__________________
http://www.plantedtank.net/forums/sh...49#post4205849

40B, T5HO, Turface, pressurized co2,EI dosing
5BodyBlade is offline   Reply With Quote Quick reply to this message
Old 10-27-2012, 12:32 AM   #6
jstehman
Planted Tank Obsessed
 
jstehman's Avatar
 
PTrader: (2/100%)
Join Date: Dec 2010
Location: LaVista, NE
Posts: 449
Default

Is your tanks ph dropping? I get a ph drop of 1 point when my drop checker shows green/yellowgreen. Maybe you have too much surface agitation? Your situation is interesting..


Posted from Plantedtank.net App for Android
__________________
Never show anyone your true potential. If you do, they will always expect it.
jstehman is offline   Reply With Quote Quick reply to this message
Old 10-27-2012, 12:41 AM   #7
jstehman
Planted Tank Obsessed
 
jstehman's Avatar
 
PTrader: (2/100%)
Join Date: Dec 2010
Location: LaVista, NE
Posts: 449
Default

Whats the working pressure of your reg set at? I had to send a stream of bubbles into my reactor when i had it at like 10psi. Ive since bumped it up to 18psi and about 4 or 5 bps and this is on a 125.


Posted from Plantedtank.net App for Android
__________________
Never show anyone your true potential. If you do, they will always expect it.
jstehman is offline   Reply With Quote Quick reply to this message
Old 10-27-2012, 02:56 AM   #8
Hoppy
Planted Tank Guru
 
Hoppy's Avatar
 
PTrader: (75/100%)
Join Date: Dec 2005
Location: Sacramento, CA
Posts: 18,975
Default

Is this the type of filter you are using?

If so, these can deplete the CO2 in the tank water very quickly unless you eliminate all splashing.
__________________
Hoppy
Hoppy is offline   Reply With Quote Quick reply to this message
Old 10-27-2012, 02:29 PM   #9
5BodyBlade
Planted Tank Obsessed
 
5BodyBlade's Avatar
 
PTrader: (2/100%)
Join Date: Feb 2011
Location: Westport, MA
Posts: 364
Default

I'll have to check my ph. Haven't done it in a while. It used to be that in the morning it would be at 6.8-6.9 and during the course of the day drop to about 6.4-6.5. I have quite a bit of flow but its not breaking the surface. A rolling boil is how I'd describe it.

My reg is still set to 30 psi. I never reduced it from when I had the diffuser on. Bad on my part. I'll have to lower it later.

The filter is the canister version of the aquatop. CF500 I think it is.
__________________
http://www.plantedtank.net/forums/sh...49#post4205849

40B, T5HO, Turface, pressurized co2,EI dosing
5BodyBlade is offline   Reply With Quote Quick reply to this message
Old 10-28-2012, 04:21 PM   #10
jstehman
Planted Tank Obsessed
 
jstehman's Avatar
 
PTrader: (2/100%)
Join Date: Dec 2010
Location: LaVista, NE
Posts: 449
Default

You sure your 4dKH is accurate?

Do you have fish/shrimp in the tank?
__________________
Never show anyone your true potential. If you do, they will always expect it.
jstehman is offline   Reply With Quote Quick reply to this message
Old 10-28-2012, 09:52 PM   #11
5BodyBlade
Planted Tank Obsessed
 
5BodyBlade's Avatar
 
PTrader: (2/100%)
Join Date: Feb 2011
Location: Westport, MA
Posts: 364
Default

It's always been acurate. Not even a year old. Does it go bad often?

Only some oto cats in there right now.
__________________
http://www.plantedtank.net/forums/sh...49#post4205849

40B, T5HO, Turface, pressurized co2,EI dosing
5BodyBlade is offline   Reply With Quote Quick reply to this message
Old 10-28-2012, 10:36 PM   #12
inkslinger
Wannabe Guru
 
PTrader: (1/100%)
Join Date: Dec 2003
Location: Taunton ,MA
Posts: 1,694
Default

I've had 4dKH and Bromo Blue being bad {old shelf life or out-dated}
inkslinger is offline   Reply With Quote Quick reply to this message
Old 10-29-2012, 01:48 AM   #13
jstehman
Planted Tank Obsessed
 
jstehman's Avatar
 
PTrader: (2/100%)
Join Date: Dec 2010
Location: LaVista, NE
Posts: 449
Default

Your pressure *should* be OK.

Maybe your setup is too new. Your plants have not acclimated to the new environment and are not putting out new growth.

Your CO2 injection setup suggests that you are putting enough CO2 into the tank water.

Maybe wait a little longer to change things until your plants are settled. I would say bump up the co2, but you are already running a decent level. 30PSI@ 6BPS in a 40g?

Can you cut back your surface agitation to see if your drop checker changes to green?
__________________
Never show anyone your true potential. If you do, they will always expect it.
jstehman is offline   Reply With Quote Quick reply to this message
Old 10-29-2012, 02:10 AM   #14
Sd760
Planted Tank Enthusiast
 
Sd760's Avatar
 
PTrader: (0/50%)
Join Date: Apr 2011
Location: Humboldt co.
Posts: 500
Default

Def eliminate surface agitation. That has to be it if theres no leak. Makes no sense. Hope we can help get to the bottom of this.
Sd760 is offline   Reply With Quote Quick reply to this message
Old 10-29-2012, 05:53 PM   #15
5BodyBlade
Planted Tank Obsessed
 
5BodyBlade's Avatar
 
PTrader: (2/100%)
Join Date: Feb 2011
Location: Westport, MA
Posts: 364
Default

Doing a test of my drop checker fluid. I put the diffuser back in to see if the fluid will get into the yellow green area.
__________________
http://www.plantedtank.net/forums/sh...49#post4205849

40B, T5HO, Turface, pressurized co2,EI dosing
5BodyBlade is offline   Reply With Quote Quick reply to this message
Reply

Quick Reply
Message:
Options

Register Now

In order to be able to post messages on the The Planted Tank Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Thread Tools
Display Modes

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 05:15 PM.


Powered by vBulletin®
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright Planted Tank LLC 2012