Hey guys, been lurking these forums and doing some research and would appreciate some feedback, I'm open to any suggestions.
So I have a Fluval Flora (8 gallon), and a Fluval Edge(6.6 gallonl)...At the moment I'm running diy in the edge and using the co2 system that came with the flora, but the double bell it came with is ugly as hell and those cartridges are expensive. Even the filter that came with the Flora is loud and annoying when throttled so I replaced it with a canister.
Anyway, what I would like to do is use a 10lb tank to run both aquariums. I was looking at this: http://www.amazon.com/gp/product/B0042OYYTS/ref=ox_sc_act_title_1?ie=UTF8&m=A34950EJPC3UHN
Along with two jbj bubble counters and glass diffusers- I'm not interested in reactors as the edge has the hob filter...
Would I need to purchase needle valves for this? If so, any recommendations? I do not mind paying a little more for higher quality parts as there's a good chance I'll be using this on a bigger aquarium in the future when I have the space for it. I'd like to spend somewhere between $200-$300.
I'm new to pressurized co2 and it's hard to search forums sometimes when you don't know what your searching for so I appreciate your help
Thanks!
http://www.amazon.com/gp/product/B0042OYYTS/ref=ox_sc_act_title_1?ie=UTF8&m=A34950EJPC3UHN
So I have a Fluval Flora (8 gallon), and a Fluval Edge(6.6 gallonl)...At the moment I'm running diy in the edge and using the co2 system that came with the flora, but the double bell it came with is ugly as hell and those cartridges are expensive. Even the filter that came with the Flora is loud and annoying when throttled so I replaced it with a canister.
Anyway, what I would like to do is use a 10lb tank to run both aquariums. I was looking at this: http://www.amazon.com/gp/product/B0042OYYTS/ref=ox_sc_act_title_1?ie=UTF8&m=A34950EJPC3UHN
Along with two jbj bubble counters and glass diffusers- I'm not interested in reactors as the edge has the hob filter...
Would I need to purchase needle valves for this? If so, any recommendations? I do not mind paying a little more for higher quality parts as there's a good chance I'll be using this on a bigger aquarium in the future when I have the space for it. I'd like to spend somewhere between $200-$300.
I'm new to pressurized co2 and it's hard to search forums sometimes when you don't know what your searching for so I appreciate your help
Thanks!
http://www.amazon.com/gp/product/B0042OYYTS/ref=ox_sc_act_title_1?ie=UTF8&m=A34950EJPC3UHN