The Planted Tank Forum banner

Drilled fluval edge build thread

1K views 3 replies 3 participants last post by  somewhatshocked 
#1 ·
Just drilled my rimless edge today, I ordered it online a while back, top came in cracked so i went topless. I just drilled it for a couple 3/4 bulkheads, and am going to do a canister of some sort, and an inline heater. Lighting will be DIY LED.

I just went for a typical putty dam, and drilled it with a ebay diamond hole saw. I tilted the drill just to get it started, and straightened it out and let the weight do the work. Any suggestions as to cheap canister setups would be appreciated.










First post BTW...
 
See less See more
4
#4 ·
Hydor is about the only thing on the US market.

There are a couple DIY threads (I think Overstocked did one of them?) here on the forum about creating your own in-line heater rig, though.

Any sources of cheap inline heaters? they seem to all run from 40 to 50 bucks, and they're all 150w plus.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top