Clear Tubing / Lily Pipes Questions
Planted Tank Forums
Your Tanks Image Hosting *Tank Tracker * Plant Profiles Fish Profiles Planted Tank Guide Photo Gallery Articles

Go Back   The Planted Tank Forum > General Planted Tank Forums > General Planted Tank Discussion


Reply
 
Thread Tools Display Modes
Old 01-14-2013, 09:56 PM   #1
Brian_Cali77
Wannabe Guru
 
Brian_Cali77's Avatar
 
PTrader: (15/100%)
Join Date: Mar 2010
Location: Scottsdale, AZ
Posts: 1,098
Default Clear Tubing / Lily Pipes Questions

Hey guys I'm about to get my 13mm Cal Aqua Lily Pipes and was advised that I need 1/2 ID clear tubing from Home Depot or Lowe's... just wondering if I need anything special to attach them, like hose clamps or something to make sure they don't fall off or get loose and leak???

It's for a Fluval 106... thanks!
__________________
Brian_Cali77 is online now   Reply With Quote Quick reply to this message
Old 01-15-2013, 12:57 AM   #2
fusiongt
Planted Tank Enthusiast
 
PTrader: (2/100%)
Join Date: Nov 2011
Location: Menlo Park, Ca
Posts: 812
Default

No you don't need special hosing. 1/2" is okay to get from Home Depot/Lowes but when I got 5/8" from there it was so freaking tough it made it much harder to setup so I ended up getting Fluval G series tubing which was a lot more flexible. ADA makes 1/2" tubing that is flexible but you probably don't need that extra expense.

The tubing is pretty tough to get over the lily pipes so that creates a tight seal so you don't need anything extra. You could loosen the tubing up by running it through hot water for a minute and then it'll go over easily on the lily pipe. Placing the tubing a few inches on the lily pipe should be good. I've never had leaks.
__________________
fusiongt is offline   Reply With Quote Quick reply to this message
Old 01-15-2013, 01:02 AM   #3
IWANNAGOFAST
I see LEDs
 
IWANNAGOFAST's Avatar
 
PTrader: (33/100%)
Join Date: Jan 2008
Location: San Francisco
Posts: 1,864
Default

You can use hose clamps. However I stopped using the tubing you get at hardware stores for my tanks. The hoses sometimes just don't fit right and are too thin causing kinks. I've been using the ones you get at the lfs, lee's brand I think and they're much better. A bit more expensive but you really only need like 6 feet total so it'd be like $10 max.
IWANNAGOFAST is offline   Reply With Quote Quick reply to this message
Old 01-15-2013, 01:15 AM   #4
Brian_Cali77
Wannabe Guru
 
Brian_Cali77's Avatar
 
PTrader: (15/100%)
Join Date: Mar 2010
Location: Scottsdale, AZ
Posts: 1,098
Default

Thanks guys for the advice! Just wondering, are the tubes at the hardware store made of a different material than that of Lee's? I'm not sure if my LFS sells it, but do you know of a 1/2 ID (Lee's or alternative) tubing online that's good?
__________________
Brian_Cali77 is online now   Reply With Quote Quick reply to this message
Old 01-15-2013, 03:57 AM   #5
OVT
Carpe Diem
 
OVT's Avatar
 
PTrader: (135/100%)
Join Date: Nov 2011
Location: SF East Bay Area
Posts: 4,475
Default

Just take your pipes to a hardware store and check the fit.
Using clamps with glass pipes is probably not a good idea.
Using a hair dryer on the hoses works wonders for a snug fit.
__________________
Courtesy * Integrity * Perseverance * Indominable Spirit * and Self Control
Tenets of TKD
OVT is online now   Reply With Quote Quick reply to this message
Old 01-15-2013, 04:08 AM   #6
IWANNAGOFAST
I see LEDs
 
IWANNAGOFAST's Avatar
 
PTrader: (33/100%)
Join Date: Jan 2008
Location: San Francisco
Posts: 1,864
Default

i think it's the same material, just the aquarium one is a little thicker
IWANNAGOFAST is offline   Reply With Quote Quick reply to this message
Old 01-15-2013, 06:08 AM   #7
Brian_Cali77
Wannabe Guru
 
Brian_Cali77's Avatar
 
PTrader: (15/100%)
Join Date: Mar 2010
Location: Scottsdale, AZ
Posts: 1,098
Default

Thanks again everyone.. what do you guys think of this tubing?
http://www.amazon.com/Watts-SVIG10-P..._petsupplies_1
__________________
Brian_Cali77 is online now   Reply With Quote Quick reply to this message
Old 01-15-2013, 04:04 PM   #8
dj2606
Planted Tank Obsessed
 
dj2606's Avatar
 
PTrader: (15/100%)
Join Date: Mar 2009
Location: Richmond, VA
Posts: 463
Default

that is 1/2 OD and 3/8 ID
__________________
Patchouli Yours
Dj
dj2606 is offline   Reply With Quote Quick reply to this message
Old 01-15-2013, 05:26 PM   #9
Rev2eight
Planted Member
 
Rev2eight's Avatar
 
PTrader: (12/100%)
Join Date: Jan 2008
Location: Chicago, IL
Posts: 164
Default

The home depots around here sell 1/2 ID tubing that fit perfectly around my lily pipes without needing clamps. I believe I paid around 7 dollars for 10ft and they have black ones.
Rev2eight is offline   Reply With Quote Quick reply to this message
Old 01-17-2013, 10:15 PM   #10
Brian_Cali77
Wannabe Guru
 
Brian_Cali77's Avatar
 
PTrader: (15/100%)
Join Date: Mar 2010
Location: Scottsdale, AZ
Posts: 1,098
Default

Okay so i got 10' of vinyl tubing (1/2" ID and 5/8" OD) at Home Depot for less than 5 bucks. Seems pretty flexible to me. I'm going to fit them on the lily pipes with the hot water as mentioned. Now my question is not the clamps on the tubes over the lily pipes, but rather the area over the tubes that connect to the Fluval 106 aqua stops??
__________________
Brian_Cali77 is online now   Reply With Quote Quick reply to this message
Reply

Quick Reply
Message:
Options

Register Now

In order to be able to post messages on the The Planted Tank Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Thread Tools
Display Modes

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 02:26 PM.


Powered by vBulletin®
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright Planted Tank LLC 2012