I recently purchased an Aquatek Premium Regulator(adjustable working pressure) for a paintball 20oz setup and I was looking for a little assistance on adjusting the working pressure.
Initially the working pressure was at about 20 PSI, and I increased the working pressure and it jumped to 40 PSI. I then backed off the working pressure adjustable knob but it didn't seem to adjust lower.
I then started to adjust needle valve etc and trying different combinations.
Right now the working pressure is at ~65 PSI, I increased the pressure but again backed off it.
I dont feel like the system is running at 65 PSI just based on how much I have it flowing. Will this go down over some time and how should i best adjust the Regulator? If i started with the working pressure and needle valve in the off position, what is the recommended method to adjust it?
Thanks in advance
Initially the working pressure was at about 20 PSI, and I increased the working pressure and it jumped to 40 PSI. I then backed off the working pressure adjustable knob but it didn't seem to adjust lower.
I then started to adjust needle valve etc and trying different combinations.
Right now the working pressure is at ~65 PSI, I increased the pressure but again backed off it.
I dont feel like the system is running at 65 PSI just based on how much I have it flowing. Will this go down over some time and how should i best adjust the Regulator? If i started with the working pressure and needle valve in the off position, what is the recommended method to adjust it?
Thanks in advance