The Planted Tank Forum - View Single Post - Complete Leak Check, CO2 pressurized system
View Single Post
Old 05-04-2013, 05:08 PM   #171
Bettatail
Planted Tank Guru
 
Bettatail's Avatar
 
PTrader: (86/98%)
Join Date: Feb 2009
Location: San Francisco
Posts: 2,431
Default

Quote:
Originally Posted by Dalban View Post
Folks should run a stop test to validate that their regulator is actually regulating accurately. Otherwise, when their solenoid closes, pressure could build up on the LP side (and then they'll dump their cylinder via the relief valve).
I think I've already mention this problem in this or some other related threads, it is internal poppet valve leak, so the LP pressure slowly climb even the regulator at off position, and the build up pressure at the LP side will eventually damage something, push through the solenoid or the relieve valve if there is one.
perform a blow test, may or may not fix the problem.

If the problem persists after the blow test, it is broken, and such problem are commonly seen on commercially available regulators.

I will add this to the steps, thanks.
Bettatail is offline   Reply With Quote