it's been a few weeks since we've had any awesome fish tank updates. since then we've been finishing the rest of the framing and new stairs. couple of weeks ago we drywalled the ceiling, yesterday was the first bit of drywall on the walls themselves... and today we went from this:
to uh... this:
we used mold resistant drywall for the walls, hence the purple/blue/perrywinkle. And, we're 80% done with the drywall. still left is the remaining wall to the right of the picture and the stairwell area.
I can't believe just how far this project has come, not just the fish tank area.
for those running larger tanks like this that have overflows, how did you setup the outflow nozzles?
and the 1st attached photo is of behind the tank. you'll see the co2 tank has a little shelf w/ a hole cut in it to keep it from tipping over. I still need to figure out all this damn plumbing!