The Planted Tank Forum - View Single Post - How to connect a Fabco needle valve to a Milwaukee regulator
View Single Post
Old 12-09-2012, 04:16 PM   #2
oldpunk78
ಠ_ಠ
 
oldpunk78's Avatar
 
PTrader: (104/100%)
Join Date: Nov 2008
Location: 96007
Posts: 5,005
Default

You should be able to just remove the old needle valve and then use two 1/8 hex nipples to make up the difference in connecting it to the solenoid and bubble counter.

Although... After thinking about it for a minute, you may want to consider not re-installing the bubble counter as I do not recall if the one on the Milwaukee has a check valve in it. I think one of the main reasons people have a hard time with needle valve on the Milwaukee is because water from the bubble counter is constantly having direct contact needle valve. The end of the needle valve is where the bubble actually forms in the counter, right? That means that when/if you just use an 1/8 hex nipple, the bubble will be coming directly from the fabco. I'd probably hit someone up for the jbj style counter witch at least has a check valve in it.

Honestly though, you'd 'probably' be fine either way.

Last edited by oldpunk78; 12-09-2012 at 04:29 PM.. Reason: typo
oldpunk78 is online now   Reply With Quote