The Planted Tank Forum - View Single Post - How to cycle low light low maintenence plant tank
View Single Post
Old 12-06-2012, 03:08 PM   #41
plantastic37
Planted Member
 
PTrader: (3/100%)
Join Date: Nov 2012
Location: Michigan
Posts: 223
Default

Quote:
Originally Posted by Diana View Post
I sometimes feel that the nitrite or nitrate sticks around in the substrate so that when I do a massive water change I am not really removing that much of the nitrite or nitrate.
I have often done something close to 90% water changes, yet not seen a change in the test result.

When I do a water change that includes draining the water through the substrate, then the test result shows that the nitrite or nitrate has dropped. Dig a small hole where it won't disturb the plants and siphon the water out through there. This will do something closer to 100% water change, and a lot of the water will flow through the substrate, hopefully removing the nitrite.

At the same time quit feeding the ammonia for a few days. The bacteria will not starve. It will give the Nitrospira (the nitrite removing species) a chance to catch up. Then start in with the ammonia again, but just a little bit.
Often the first group of bacteria, the ones that remove ammonia grow so fast that they just keep on producing the nitrite so fast that the nitrite removing bacteria cannot keep up.
Okay so 2 days ago the amm and nit dropped to 0ppm. So I decided to test the system per your write up and add 24 drops of ammonia. This brought the amm up to 5ppm.

Just now amm has dropped to 0 ppm and nit has dropped to about 0.25ppm. So perhaps a tad over 32 hours.

In your write up it says it should drop to 0 within 24 hours correct? So I am probably still not there, but perhaps on the verge?

Thanks for any further guidance!

Last edited by plantastic37; 12-06-2012 at 04:40 PM.. Reason: mistake
plantastic37 is offline   Reply With Quote