The Planted Tank Forum - View Single Post - Building UGJ, need advice
View Single Post
Old 11-18-2012, 02:28 AM   #9
essabee
Planted Tank Obsessed
 
essabee's Avatar
 
PTrader: (0/0%)
Join Date: Oct 2006
Location: Ranchi, Jharkhand, India
Posts: 429
Default

Quote:
Originally Posted by In.a.Box View Post
what a UGJ? Heard of UGF but never UGJ.
You would have found your answer if you had gone through the posts on the thread.

Quote:
Originally Posted by BenderBendingRodriguez View Post
Undergravel jets for water movement I believe.
Quote:
Originally Posted by Hoppy View Post
Any system that pumps tank water under the substrate, so it passes through the substrate back to the tank, is a under gravel filter. Your reasons for using it don't change what it does. The goal should be to get roughly equal flow from every hole in the tubing. That requires that the total area of the holes not be much greater than the cross section area of the inside of the tubing. If the total area of the holes is much less than the area of the tube ID, you get strong jets of water from each hole. If the total area is much more than that of the tube ID, you get slower jets, and the holes farthest from the inlet to the tube may have very little flow out. When I was using this type of filter I didn't notice any stirring up of the mulm on the substrate. The flow from the jets gets diffused so much by the gravel that you can't see anything happening.

If there isn't much gravel over an area of the jets, you get a miniature gravel volcano, which doesn't look good. So, it seems that you have a choice of no visible effect or a bunch of miniature volcanoes.
__________________
If you have a choice, you have a problem, till you elect your choice. No choice, no problem, only consequences, learn to live with them.
essabee is offline   Reply With Quote