Thank you very much for the link, Great idea/setup. Would work for me if I had a larger tank, and if I wanted to go the ugf route.
Based on the calculation you provided, I will need 200 square inches for the ugf, (based on the pump sitting here) my tank bottom is 288 square inches (12"x24").
Seeing as the gravel is 80% covered in plants/rocks/wood, I don't think this will work for my application.
Also I don't like pulling water through the gravel, due to my tank being overstocked, my biggest problem right now is constant gravel vacuuming. (as in every 3-5 days) I can see my intake pipes getting plugged quite often.
I am attempting to create an upwards current under the gravel on as close to 100% of the tank bottom as I can.
It is a great idea/setup, it's just not what I am attempting to do.
I'm trying to do more of a reverse ugf setup with a higher flow than just ugf plates with a reversed powerhead. (have to push through 4" of gravel on one end)
What kind of pumps did you use in your system? Do they "chatter" when backloaded?
Last edited by Sploosh; 11-17-2012 at 03:24 PM..
Reason: Spelling correction