The Planted Tank Forum - View Single Post - Water solubility of equilibrium
View Single Post
Old 10-11-2012, 04:14 AM   #3
Sotty
Planted Member
 
PTrader: (0/0%)
Join Date: Aug 2012
Location: Ann Arbor, MI USA
Posts: 282
Default

or if the temperature in your house drops.

How much of this solution are you tearing through? I fully understand the desire to get max concentrations to decrease frequency of changeouts. I've never done this personally for a tank. Long ago, I was a chemist and when we very rarely stored inorganic solutions made with solutes with low solubility, such as CaSO4, to near their solubility point. Over time, with temp changes in the room the risk of precipitation was too high. And once you precipitate some out then you have no idea what you are dosing. In the long run this probably wouldn't be the end of the world, but not ideal either.

Have you tried the recommended dilution from Seachem?

or alternatively you could start with 800mL of water (I would go room temp) and get as much to dissolve as possible, keeping track as you go for future batches. Then after just have a couple crystals left on the bottom that won't dissolve top off to an even liter. This should give you just under a 20% safety margin with the solubility that should account for temperature fluctuations, minute amounts of evaporation, etc.

I would not use hot water if you plan on keeping the solution for an extended period of time. There is nothing wrong with using hot water in the future as long as you know that the amount that you put in will stay in solution in room temperature water, but you will be able to get a lot more to go into solution using the hot water. When the solution cools it will become super saturated and will eventually precipitate out.

Sorry I don't have any had numbers, but I have a gH of 8 out of the tap so I've never used the stuff.

Good Luck.

Last edited by Sotty; 10-11-2012 at 04:47 AM.. Reason: added info
Sotty is offline   Reply With Quote