The Planted Tank Forum - View Single Post - 50G with 30G sump - month 10 update
View Single Post
Old 09-07-2012, 04:50 PM   #60
crazymittens
Planted Tank Enthusiast
 
PTrader: (0/0%)
Join Date: Jun 2012
Location: Oshawa
Posts: 663
Default

Ok, list time...

Tonight
  1. Drain water from tank and sump
  2. Remove pumps/heater
  3. Clean tank and sump glass (exterior)
  4. Caulk chipped area of overflow (trim Saturday)
  5. Disassemble plumbing (check out that leaky bulkhead) & clean
  6. Fabricate/paint hood

Saturday
  1. Trim caulking patch on overflow
  2. Move sump into place
  3. Move tank into place
  4. Check level of tank (ensure weir will be even)
  5. Plumbing dry install, measure, cut
  6. Plumbing glue-up
  7. Fabricate/install brackets to support plumbing
  8. Run power & set up UPSes
  9. Substrate layout (hardscape->MTS->gravel)

Sunday
  1. Do water tests
  2. Establish baseline in notebook
  3. Pick up ammonia & dechlorinator/fish food

Jeepers! Lots to do. I need to figure out a solution for a cover/hood - at this point will try and make one (wood & paint) rather than do the glass route - too expensive at this stage. Lots of DIY stuff out there on light hoods that I've seen, so not too difficult.
crazymittens is offline   Reply With Quote