The Planted Tank Forum - View Single Post - DIY inline heater build
View Single Post
Old 07-05-2012, 02:41 AM   #5
PlantedRich
Planted Tank Guru
 
PlantedRich's Avatar
 
PTrader: (1/100%)
Join Date: Jul 2010
Location: Pflugerville, Tx
Posts: 3,201
Default

Heaters are improving and the Penn-Plax is among the worst design-wise. Just knowing Ebo-Jager, I would expect better and I can see from the outside some good points. The design of the top of your heater looks good. If you spill water on your heater it is likely to run off the edges. The brown cover on the Pen-Plax is a cup where the adjustment sets. Any water spilled on it will set in the cup and eventually find it's way along the screw and inside. I know we are not supposed to get water on them but that is like telling a five year old not to get wet when it rains. Just happens!
PlantedRich is offline   Reply With Quote