The Planted Tank Forum - View Single Post - Convert Lux meter to PAR meter?
View Single Post
Old 06-13-2012, 11:21 PM   #12
Planted Tank Guru
Hoppy's Avatar
PTrader: (79/100%)
Join Date: Dec 2005
Location: Sacramento, CA
Posts: 19,541

Originally Posted by mistergreen View Post
I use a heyco grip cord to waterproof where the cable meets the housing but I'm going from beneath because it needs a flat surface, not a curved one from the side.

I use silicon to seal the cap.
So, the curing silicone fumes don't do any harm? And, I know it doesn't adhere strongly to acrylic, but there shouldn't be any stress on it to keep it from sealing. I can't see any way to ever get back into the sensor housing once I seal it, whether with silicone or anything else, so is there a good reason not to use high viscosity acrylic cement to seal the lid on permanently? The solvent fumes? Remember it is threaded on too.
Hoppy is offline   Reply With Quote