Originally Posted by sketch804
Oh ya any time! Hmm, I am not really sure, but that sounds about right for the GPH, but I have heard that those rates aren't exactly accurate. But if my flow was a little slower like in you canister than I wouldn't get any bubbles coming out of my tank..As far as this reactor is concerned I don't believe low flow matters, it's when the flow is too high then it becomes a problem. When bubbles are expelled through the output then that just means it is wasted CO2..so with lower flow the CO2 is fully diffused/absorbed before it exits and there is no wasted CO2..So truthfully I think you will be alright! I don't think there is any set limit for the low flow on this reactor..just as long as there is some decent flow you are good to go..If I were you I would go for it! BEST thing I ever built for my tank haha!
I love this website, you have people such as you that are so informative and motivating! I'm going to go for it and build it. I'll post my results after i have it connected so people with filters like mine with low flow will have comparison. Thank you once again for your time and information!