The Planted Tank Forum - View Single Post - EOTD worry warts: Meet your God! LOL @ DIY Regulator
View Single Post
Old 02-17-2012, 12:10 AM   #1
proaudio55
Planted Tank Enthusiast
 
proaudio55's Avatar
 
PTrader: (0/0%)
Join Date: Oct 2011
Location: Blaine, Minnesota
Posts: 641
Cool EOTD worry warts: Meet your God! LOL @ DIY Regulator

If you look up the definition of "a solution in search of a problem" it should link to this build!
Forward:
EOTD stands for "end of tank dump" and a cheap regulator like mine is known to have major pressure swings as the cylinder runs out of CO2. By adding an additional 2 regulators in series, any pressure fluctuations will be eliminated. In reality, one additional regulator would be sufficient, but I'm a high-roller with a soft spot for prop comedy.


So here's my DIY 3 stage regulator.
Stage 1 is a cheap harbor freight inert gas regulator:
Stage 2 and 3 are both hardware store inline compressed air regulators

Gauge 2 is: 0-60PSI Mcmaster-carr P/N 3846K14
Gauge 3 and 4 are 0-30PSI Mcmaster-carr P/N 3846K12

The gradient on this regulator train is:
800PSI
40PSI
20PSI
10PSI

This was during the build . . . It looks strangely like something you'd find at a 'crack house'. . . I can quit planted tanks anytime, it's under control, I swear!!

http://www.plantedtank.net/forums/pH...111_EOTD1c.jpg


All hail the 20lb aluminum CO2 tank of glory! I've been running this bad-boy for over a year now on a single fill.

http://www.plantedtank.net/forums/pH...112_EOTD2c.jpg


Here was when I just set it up; Note the corrected pressures. I found out my diffuser needs about 10PSI to work right.

http://www.plantedtank.net/forums/pH...113_EOTD3c.jpg


Go ahead and laugh, I found this whole build quite amusing!
proaudio55 is offline   Reply With Quote