The Planted Tank Forum - View Single Post - Metering(needle) valves selection for our CO2 pressurized system
View Single Post
Old 05-11-2011, 06:50 AM   #9
Wannabe Guru
ADA's Avatar
PTrader: (1/100%)
Join Date: Dec 2010
Location: USA
Posts: 1,084

Nice!!! Can you tell me which one is the best? I'm having some inconsistencies with my paintball diy.. it won't stay at 1bps. Either stops after a few hours, or worse, increases to over 20bps.

Will all of those valves you listed be strong enough to control the full force of a paintball tank? (800+ psi) Because the paintball tank is only capable of either on or off, right? So the valve needs to be strong enough that it won't burst under that pressure.

ADA is offline   Reply With Quote