The Planted Tank Forum - View Single Post - DIY PCB's for DIY LED Systems.
View Single Post
Old 05-06-2011, 03:49 PM   #8
intermediate_noob
Planted Tank Obsessed
 
intermediate_noob's Avatar
 
PTrader: (15/100%)
Join Date: Jan 2007
Location: ABQ, New Mexico
Posts: 306
Default

Quote:
Originally Posted by evilc66 View Post
Depends on what you enjoy doing. Learning a new skill like pcb design is a challenge, but a fun one. The CAT4101 drivers are easy to use, and certainly cheap enough to consider. The only drawback is that they are a linear driver, which means that the excess voltage difference between the LED forward voltage and the source voltage gets burned off in heat through the driver chip. To minimize this, you have to keep the delta between the two as small as possible. This typically means either careful planning of your LEDs for a fixed output power supply, or you get a power supply that can be adjusted slightly to minimize heat related issues.
Thanks EvilC, I have been reading your threads and others on the salt water forums and would really like to get into the DIY aspect of this so I think my mind is made up.

My thoughts were to start small and build a single driver board to light smaller thanks and then graduate up to a larger setup. Again, thanks for the reply and the information.
intermediate_noob is offline   Reply With Quote