|02-26-2013 05:54 PM|
|Hoppy||CO2 easily dissolves into water in large quantities, compared to oxygen, which doesn't easily dissolve into water. Those air bubbles are very unlikely to put much oxygen at all in the water. A wet/dry filter is a good way to dissolve a lot of oxygen into the water.|
|02-26-2013 12:32 AM|
Anyone know? I'm in research mode now
|02-25-2013 06:47 PM|
|sarahspins||Don't feel bad - I think air stones are one of the most misleading aquarium products sold They work well, for what they do, they just don't work the way most people assume.|
|02-25-2013 06:05 PM|
|DrakeScree||I did not realize that was how o2 got into the water. Makes sense though, and I probably should have figured that out, had I thought about it more. Thanks all|
|02-25-2013 05:21 PM|
|02-25-2013 05:13 PM|
Most of the inline diffusers need a fairly high PSI to work (35+).. I'm not sure an air pump is capable of generating enough pressure to do that. That said, an air stone itself doesn't actually add much oxygen to the water - what it does is create a surface disturbance and causes the water to flow upwards towards the surface, which is where the water is oxygenated, so adding air into your return line might not really do much.
If you can increase the surface agitation caused by your filter's outflow, that should provide more than adequate oxygen to your tank.
|02-25-2013 05:11 PM|
Re: Using inline co2 for o2 instead
Theoretically, it would work.
Sent from my Galaxy Nexus using Tapatalk 2
|02-25-2013 05:09 PM|
Using inline co2 for o2 instead
I would like to avoid putting an air stone in my tank. Can I use a inline co2 diffuser and hook it up to an air pump to do this?