|02-19-2013 02:21 AM|
|gnod||yup, gonna do soem water changes for next few days since i just set it up. it's less muddy after i just changed it twice and hope that by end of week it should be fine. i don't want to plant it not cause it'll just cover the plants afterwards. i remember this just now actually thinking back to when i first did this with AS.|
|02-19-2013 02:09 AM|
With liquid ferts you are paying for a whole lot of water and someone else's idea of how much NPK/micros you should be dosing.
I would plant it, get it to how you want it and then do a big water change and leave it be.
|02-19-2013 01:27 AM|
|JoraaŃ||I would do much water change till it clears and only introduce fish, shrimp etc..if it will be planted tank only without animals...then you are good to go.|
|02-19-2013 01:01 AM|
thanks all for your responses!
yes, for now i am going to get some dry ferts premixed and going to dose to see how things go from there. now that i have that taken care of - my other question!
i copied and pasted from another thread so here it is
"so i recently restarted a tank i was storing for few months now, and along with it the old AS i had in that tank.
After i filled the tank with water it was the usual cloudiness but after a day i noticed that the top surface layer is significantly reduced to powdered form... i think if i were to plant anything it would go all over the place!
any suggestions? should i remove the said powdered form of AS by just creating a lot of distburance in the water and quickly suck out the entire water?
or should i just hope that it'll eventually go below the top substrate level, as i think smaller particles normally do over time. "
|02-19-2013 12:50 AM|
Perhaps this will help you guys to understand dry dosing.
Since you have a smaller tank (4 gal.) you can get premixed and dose in liquid form, 1-2 ml twice a week.
|02-18-2013 11:55 PM|
|owens81jw||also, since your is only 4 gallons, u can use liquid ferts too|
|02-18-2013 11:49 PM|
there's a fellow TPT member who sells dry ferts for a good price
NILCOG, he was very helpful with me
|02-18-2013 11:39 PM|
|02-18-2013 11:29 PM|
Great resource right here.
Also, check out Tom barr's, barreport.com
|02-18-2013 11:27 PM|
|jimmytruong87||Why you use dry fert ? Not liquid fert ?|
|02-18-2013 11:05 PM|
|homemadepopcorn||I bought some stuff from aquariumfertilizer.com... good stuff but it isnt as cheap as the link furfins posted. Now I'm kicking myself in the butt.|
|02-18-2013 07:55 PM|
Joraan sent this to me since I'm looking for GH booster. Check it out might be what you're looking for.
|02-18-2013 07:03 PM|
If you got dry ferts, here is a good cal for you to mix up the solution. I think the stock 26w is way too bright, I actually use a 13W GE 6500k, stock light without co2 algae algae, my experience only.
|02-18-2013 06:45 PM|
so... i am considering take a real look at learning how to dry fert my 4 gallon nano tank. i'm hoping that i go beyond the average "green" looking plants and get some more lush, healthy green in my plants.
i'm going to start researching today but, does anyone have any resourceful sites they used they'd be willing to share with me?
also, eventually i'll need to purchase dry fertz so.. if you got some, let me know!
my set up-4 gallon finnex, 26w about 3-4 inches from top of water (not sure if it's high light but i'd have to assume it's close to it since i grew glosso well before), and diy co2. i guess that's a fairly low tech tank?
i may venture into pressured co2 later but frankly i'm too paranoid to do so.. haha. i don't like paintball tank method unless there's a regulator and i haven't seen any good ones out there yet.