|Topic Review (Newest First)|
|02-19-2013 12:59 AM|
The right principle for design is there, but as mentioned, I would be a little worried about using just one suction cup to hold the drop checker in place. You may find yourself using a lot of 4 dkH reference solution and bromothymol blue to get the liquid visible past the opaque lid.
It might be a little big as well (I wouldn't want to put that into my nano aquarium )
Finally, people might ask about that upside down Mickey Mouse
|02-19-2013 12:10 AM|
|wachnlurn||I put it in a glass of water, it wasnt filled up. but yes its pretty bouyant. I shouldn't need it to be too deep to test the Co2 though? I can always add another suction cup if needed.|
|02-18-2013 11:58 PM|
|RoyalFizbin||Have you tried filling it with water and putting in the tank yet? It looks like its going to have a pretty big volume of air. I wonder if it might make it too buoyant for the single suction cup.|
|02-18-2013 11:21 PM|
Working on a DIY Co2 drop checker using baby bottle
So the past few days I've been worried about Co2 levels in my new 55g, and was trying to find a cheap solution where i could just use stuff i already have for the aquarium or laying around the house.
Digging through the cupboards i noticed an old baby bottle so lets begin.
Inverted the nipple and using Loctite Gel I superglued it to the bottle.
Cut off just the very top of the nipple. This is where the Co2 from the aquarium will enter the testing chamber.
Now i should just need to work on the solution. I previously picked up some distilled water from the store. I'm going to do some research on how to do this.