|Topic Review (Newest First)|
|12-31-2012 08:30 PM|
|12-31-2012 07:37 PM|
Limited space :P.
The heated up is a good idea. Heat cuts well.
|12-31-2012 07:26 PM|
And has been said. White vinegar. Great for cleaning coffee makers. Try heating it up a little. in fact we even use it warm on our press rollers to get off the buildup and to neutralize the rollers.
|12-31-2012 04:32 PM|
I understand it wasn't intended to be rude, but you didn't offer up what you just said in your original post. Had you said that, it would have been a different story.
I find that if people (including myself) don't make the best of every purchase, you wind up with way too many tanks.
My take is this doesn't have to be a break the bank hobby.
|12-31-2012 04:21 PM|
Someday I may clean them up but they will still be utility tanks.
|12-31-2012 04:20 PM|
White vinegar plus a lemon cut in half. Spray the edges with vinegar, let it set for a few minutes, and then take the lemon and just scrub it on the tank.
Seriously. Lemons. I use them to clean the water marks off my faucets, sinks, and tubs. It works great on glass and I'm 99.9% sure it's nontoxic.
|12-31-2012 03:17 PM|
Not everyone buys into a consumerist mind-set, either.
One of the handiest "tools" in my aquarium setup is an extra large cat litter pan. Easier to put small tanks rim down in it to soak the rims than try to keep draped rags wet, also great for soaking glass covers and other equipment. As well as rinsing substrate, holding/sorting plant clippings, etc. Cheap and nigh on indestructible.
|12-31-2012 02:43 PM|
|acitydweller||i used white vinegar. not sure if its any different than normal vinegar but it was recommended to me many many moons ago, hence me passing this tip on. good luck|
|12-31-2012 02:41 PM|
Why would someone go spend $10.00 on a new tank when they could put a little elbow grease into an old one?
Some people don't have money to throw around, so I find suggestions like that rude.
OP, when I cleaned my hardwater, I just used warm water and a clean rag. It eventually comes off, but you're probably better off with vinegar. Good luck!
|12-31-2012 01:28 PM|
|GraphicGr8s||Why waste the time? 10 gallon $10.00.|
|12-30-2012 07:37 PM|
|ffmd212||thanks for the replys i will get to work on it today!|
|12-30-2012 07:25 PM|
|Kathyy||You have to use lots of it though. Soak rags in it and lay them on the spot you need to work on for a while before scrubbing. You can use single edge razor blades to help scrape and the original Mr. Clean sponge can help get off the last of the residue if you have some around. Be careful around the silicone of course, too many nicks and you get to reseal the tank too!|
|12-30-2012 07:00 PM|
Originally Posted by Knotyoureality View Post
I agree. When I cleaned mine Vinegar worked great for me.
|12-30-2012 06:57 PM|
|Knotyoureality||Vinegar does a pretty good job and won't later poison anything.|
|12-30-2012 06:42 PM|
Cleaning an old tank
I have a used ten gallon I want to set up, and it has hard water deposits all around the edge. What is the best way to clean this?