|03-12-2014 05:14 AM|
|talontsiawd||The Belem looks good but I like the hydropiper mixed in better. Why did you remove it? Belem over took it? Anyway, it's nice looking. I don't think I will ever do any sort of DHG combined with something on a tank I cannot babysit every day. On my last tank, I ended up just yanking up the DHG and replanting some, such a hassle.|
|03-12-2014 05:01 AM|
pulled the hydropiper. (sadly). but the belem really started to fill in. I noticed that after my last major trim I was having some bga issues. I don't think that I was doing enough water changes or maybe I trimmed too much. everything bounced back however at very different rates. I should maybe have planned my trimming a little more economically. The belem that I trimmed, a lot of it died off then new growth set in. also the bio film on top of the tank became really thick when I went a week without water changes. When I pushed my finger through it, it separated like shards of glass. really wild. anyway, just belem in the tank now. am moving soon so I'm just going to let it grow. I purchased a bubble counter to replace my diy syringe one. that seemed to develop leaks over time. here's what I snagged. it's pretty awesome.
here's the tank in its current state. Almost daily water changes now, using the hose to suck off any bga remnants. manual removal has proven to be way more effective than any h202 treatment. also did a major filter cleaning etc.
just belem, snails and rocks.
|02-02-2014 05:06 AM|
I agree with trigger below. sounds like you just have air in yours as well. If you tilt your filter the bubbles should dislodge. make sure all of your connections are secure. You can always check your impeller, but if your filter is only 6 months old, probably best not to mess with it unless the noise coming from it is bothersome.
|02-02-2014 04:59 AM|
|02-02-2014 04:51 AM|
|The Trigger||That just means you have some air trapped in there. My 2215 does the same thing until I pick it up while it's running and shake it around until I get all of the air out. Usually only happens after I open it for some cleaning, or after I do a water change and the water level drops below the intake screen|
|02-02-2014 04:30 AM|
Still enjoying this tank but as for the Eheim, I read above about it having bubbles? My 2215 will randomly throw out a few seconds of bubbles with a grinding noise. It is not very old; roughly 6 months; and I have never broke or replaced anything.
So to sum up fixing the problem the way you did would be to take out the magnet and gently replace it into the plastic housing with a final lubrication of everything with Vaseline?
|02-02-2014 04:27 AM|
|plantbrain||E. hydropiper is touchy when it comes to any chemicals, avoid using them near the plant.|
|02-02-2014 04:17 AM|
almost time to bleach the pipes.
filter is absolutely, 100% silent. I started to hear more noise develop later into the night and was wondering whether it was from the o2 from the plants or co2 bubbles getting trapped that was causing it. I tilted the filter a little and expelled a bunch of bubbles that had been trapped. after that...silence...we are golden.
|01-27-2014 08:03 PM|
trimmed the dhg belem this morning. it's starting to really fill in in the back where I removed the e acicularis. didn't touch the hydropiper though. I'm letting it get much much thicker before I trim it again. Also had a little issue with some h202 that I used to treat a spot of bga a little while back. the section of hydropiper that was in contact with the h2o2 has been damaged, but the new hydropiper runners are moving in and are slowly replacing the treated bga section.. noticed a couple spots of floating petroleum jelly on the water surface from when I prepped the impeller. not a problem though. I also don't have any fish in this tank. just snails, worms and all the other substrate critters. haven't seen any new gda in a while either. just the usual small sections low to the substrate. still so far so good and all systems go.
|01-26-2014 04:16 PM|
|Fat Guy||maybe I spoke too soon. my long winded excitement above aside. woke up and the buzz was back. took it apart again. this time added the petroleum jelly to anything moving with the impeller or on anything that would cause any friction. put it on the o-ring as well. and...too soon to say but....VOILA!! ....(hopefully for good). I noticed that one of the metal fasteners on the outside wasn't secure as well. for now...can't hear the filter but it is working great...fingers crossed.|
|01-26-2014 04:59 AM|
as for the eheim impeller issues... I have resolved them!! holy mackerel was that a process. I learned a lot about the eheim classic and the solution was extremely simple. when I got the replacement impeller the magnet and the plastic prop were detached. when I first put them together i think i used too much force joining the two so that when the prop spun, the bottom of the plastic prop was touching the housing. so I emptied all of the water out of the filter first....then took the impeller out. made sure that the bushings were seated flush and correctly and checked that there wasn't any random debris in the chamber. side note- I had watched a great little vid online of a kid putting petroleum jelly on the impeller to reduce friction. thought that was very clever, but I didn't go that route. Instead, I just took my time and put the pieces back together gently after I detached the magnet from the plastic prop. I made sure that I didn't use too much force this time when I reattached the magnet to the plastic prop. this gave/added a little bit of clearance...like a paper-thin amount of clearance between the plastic prop and the housing when it is seated on the ceramic rod in the motor. then I carefully hooked everything back up. primed the filter by opening the intake chamber valve first, then the outtake chamber valve which allowed the water to rush in and push any of the air out; crossed my fingers; plugged the power cord into the wall outlet and...VOILA!!
At long last!!! absolutely zero noise. no air bubbles. no random vibrations....didn't have to tip the filter or anything. just running seamlessly. so smooth. what I learned: I was the problem (as I often am). There was absolutely nothing wrong with the filter. who knew that I'd learn a valuable lesson after all. patience patience patience!! now if only I can ride that wave into tomorrow and tomorrow and tomorrow.
best to all,
|01-26-2014 03:37 AM|
|lamiskool||hmmm all my eheims I have are silent...also ive broken my impeller shaft many times while cleaning so I know your pain haha|
|01-26-2014 03:29 AM|
|The Trigger||Great tank. Love the simplistic layout|
|01-26-2014 03:27 AM|
Awesome carpet..!! :thumbup:
Sent from my Blackberry Playbook using Tapatalk2
|01-26-2014 03:21 AM|
|dj2005||Awesome to see that your Mini M is still going strong! It's fun to see the various scapes over the years.|
|This thread has more than 15 replies. Click here to review the whole thread.|