|12-12-2012 01:12 AM|
|STS_1OO||Tempered glass in the US is rated above 9,427 PSI. With a rimmed tank, you have little to worry about as far the glass breaking. With the edges falling directly above the load-bearing sides of the stand, you have little to worry about as far the integrity of the stand goes (as long as this isn't a cheapo stand).|
|12-12-2012 12:24 AM|
This will take all your worries away
|12-11-2012 10:18 PM|
|Gene the green priest||thanks guys|
|12-11-2012 09:59 PM|
|Bubba Shrimp||If it has a plastic rim the bottom of the glass doesn't touch the surface it is suspended. It should be fine if all the plastic is supported and it is level. Maybe spread out substrate evenly and don't get to heavy of drift wood or rocks.|
|12-11-2012 09:05 PM|
|12-11-2012 08:53 PM|
|Gene the green priest||it's tempered glass with the black edge rim .|
|12-11-2012 08:42 PM|
Is it a typical glass tank with a plastic rim? or rimless glass, or acrylic?
If it has a plastic rim on the bottom, that is all that needs to be supported. Even if you had a solid platform, the glass wouldn't flex enough to need support in the middle.
If it's acrylic, the entire bottom should be evenly supported (if you are putting it on an open center stand, get a nice chunk of plywood cut to fit, and then you can set the aquarium on that)
I'm not certain about rimless tanks. I would think that they would be fine supported by just the edges, but I'd like to hear from someone with experience on those.
|12-11-2012 08:30 PM|
|Gene the green priest||
46 g bowfront stand question
Hi everyone, trying to get back in to the planted tank hobby
My 46bow sits on the stand that is hollow in the middle, meaning that fishtank is support by the edges only.
I'm a little scared to put 80lbs of substrate and all that water in the tank that has its bottom just suspended in the air.
Any ideas? should it be fine? or do I reinforce it?