The Planted Tank Forum - Reply to Topic
Planted Tank Forums
Your Tanks Image Hosting *Tank Tracker * Plant Profiles Fish Profiles Planted Tank Guide Photo Gallery Articles

Go Back   The Planted Tank Forum > Specific Aspects of a Planted Tank > Shrimp & Other Invertebrates > Are all check valves created equal, low air pressure problem

Thread: Are all check valves created equal, low air pressure problem Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the The Planted Tank Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
12-09-2012 04:45 PM
Soothing Shrimp Sounds like you have the ideal air pump set up.
12-09-2012 04:33 PM
ravensgate
Quote:
Originally Posted by Soothing Shrimp View Post
Yeah, I don't use check valves either.

Keep in mind that getting air to your filter depends on length of hose and how deep the filter is in the water, too. (You can actually cheat a little if there is not enough air pressure on a specific filter to make bubbles, by moving it higher in the tank. )
The sponge filter basically sit on the bottom of the tank with the top plastic piece about 1/8" below the water surface (short tank). The tube running from air pump to filter is, oh, maybe 7-8 inches long so I'm trying to keep the distances very short.
12-09-2012 03:15 PM
Soothing Shrimp Yeah, I don't use check valves either.

Keep in mind that getting air to your filter depends on length of hose and how deep the filter is in the water, too. (You can actually cheat a little if there is not enough air pressure on a specific filter to make bubbles, by moving it higher in the tank. )
12-09-2012 12:55 AM
ravensgate
Quote:
Originally Posted by GeToChKn View Post
Try it without a checkvalve and see if you get better pressure.

If you put your airpump above the tank, it won't usually drain water out as the water won't travel upwards. To be honest, I've never used a check valve. lol.
I mentioned it in my original post that without the check valve it has great pressure So hubby and I actually couldn't even blow air through the check valves on it. Found a different kind that is doing much better. However, I think I'll just have him put a little shelf on my wall above the tanks and run them without check valves. That's going to probably be my smartest bet.

Thanks for the others posts as well, I just wasn't sure if they were all the same but finding that other one tells me that no, and the ones I have on there were crap.
12-09-2012 12:18 AM
GeToChKn Try it without a checkvalve and see if you get better pressure.

If you put your airpump above the tank, it won't usually drain water out as the water won't travel upwards. To be honest, I've never used a check valve. lol.
12-09-2012 12:05 AM
lipadj46 I have an alita pump that can run 24 airstones but if I put one of those cheap plastic check valves on it barely any air will flow through. The back pressure will be bad for a diaphragm pump too. I don't use a check valve because of this, have not found a good cheap one. The swagelock check valves would be great but would be expensive to buy 24 of them.
12-09-2012 12:01 AM
ThatGuyWithTheFish No, the best would be the $10 brass ones. But most people use those for CO2.
12-08-2012 11:55 PM
ravensgate
Are all check valves created equal, low air pressure problem

Are they all made the same? Or are some more constricting than others? I just got a brand new Fusion 700 Air Pump rated to run 12 things off of it. And all of the instructions show with a check valve figured in to that equation. I put the check valves on just to run one small sponge filter and one small air stone (all in close range to the pump itself) and the air pressure is ridiculously low. I've checked the check valves under water and they aren't leaking. These are just cheap ones I got at Walmart so are there other brands that don't restrict the air flow as much? Without the check valves attached, yes this is a very powerful air pump that could definitely run a lot more on it. I got it to run 3 small sponge filters but there's no way in hell it will be able to do that with these check valves on.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT. The time now is 09:47 PM.


Powered by vBulletin®
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright Planted Tank LLC 2012