|Topic Review (Newest First)|
|11-26-2012 02:23 AM|
|bobc4d||for work we use hach.com, you can call them and talk to the techs, tell them what you have and need for, they can direct you to what you need.|
|11-25-2012 06:11 PM|
Using the powder it came with, did you mix these powders with RO or distilled water?
You ought to be able to use RO or distilled as a 3rd reference, but if either of these are exposed to the air they can pick up CO2 and the pH of this will be lower. No way of telling.
|11-25-2012 05:56 PM|
|D-raw||Can someone link me to the powder I need to get|
|11-25-2012 04:08 PM|
|Rev_jim_jones||Well if it is the same cheap one I got from Ebay then you need to buy a different brand of calibration fluid/powder. The one i received where PH 7.01 (was actually 7.72 with RO water). And yes it is single point calibration.|
|11-25-2012 03:25 PM|
|D-raw||So should I use distilled water the one I buy in jugs at stores and just use that as a 7ph calibration?|
|11-25-2012 01:22 AM|
Originally Posted by D-raw View Post
I suppose if it was a cheap pH probe, it'd only be a one point calibration
|11-25-2012 01:18 AM|
idealy you should use DI water to mix the solution, which has most chemicals removed and is usually 7.0 pH (neutral) because you are using tap water it is changing the value of the pH solution. you could use a pH buffer to help with using tap water
at work I have a Hach pH meter and do a 3 point pH calibration using pH standard solution of 7, 4 and 10.
|11-24-2012 09:22 PM|
|D-raw||It's the one probe in the back. It's a yellow one I got off eBay|
|11-24-2012 08:57 PM|
|Darkblade48||What pH probe do you have? Is it a one point or two point calibration probe?|
|11-24-2012 04:07 PM|
|Centromochlus||There should be two places to adjust the high and and low end separately. What type of pH meter is it?|
|11-24-2012 04:04 PM|
How to calibrate my ph meter?
I just bought a digital ph meter. It came with
6.86 powder and
I mixed two solutions. One with 1/4 cup of tap water and 6.86 solution and one with 1/4 cup 4.00 solution.
When I place my meter in the 6.86 ph water, I calibrated it so it's around 6.85
But when I place it into the 4.00 ph solution, it reads 4.3. I'm stuck on how to calibrate it.
I tested it In my fish tank with 7 ph tap water buffered by Amazonia new and it reads less than 6 ph. Something's wrong. I know the ph should be around 6.5 that's what my liquid ph tester reads. So the meter is calibrated low. But eve if I crank it up, the 4.0 solution and 6.86 will be too high. What do I do?