The Planted Tank Forum - Reply to Topic
Planted Tank Forums
Your Tanks Image Hosting *Tank Tracker * Plant Profiles Fish Profiles Planted Tank Guide Photo Gallery Articles

Go Back   The Planted Tank Forum > Specific Aspects of a Planted Tank > Substrate > substrate not holding plants

Thread: substrate not holding plants Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the The Planted Tank Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
11-21-2012 09:31 PM
Allentan97 planting the plants not too close helps a lot, and put it about an inch 3/4in down
11-16-2012 01:28 AM
Teachercjc thanks for all your comments. I'll give it a go!


Posted from Plantedtank.net App for Android
11-15-2012 09:36 PM
dmagerl I trim the tops to about 1 inch length when planting. There are very few roots on the bottom of the plant so I take some off the top to keep things balanced. Doing this seems to result in less yanking ability and it stays in the substrate better.
11-15-2012 09:29 PM
Kathyy Plant the hair grass deeper. Your substrate is a fired clay, correct? It is light weight and easy on delicate plant crowns so deeper is fine. My hairgrass will grow crowns 2" below the surface of the substrate at the tank pane! I take the tiny clump by the roots with my forceps [works better than tweezers for me] and pull the plant under the substrate so the crown is maybe 1/2" covered by substrate. Let go of the roots and pull the forceps out at an angle. The one time I did this with no water in the tank the plants stayed down better as the substrate falls around the roots when the tank is filled. When you plant in water the plant can float up as you remove the tool as you well know!

Lots of other grassy carpeting plants to choose from but any that form lots of tiny crowns and fine leaves are going to have fine roots too. Blyxa japonica sort of looks like a clumping grass but is really a stem plant with thin leaves. The stems easily break before roots have grown into the substrate so aren't very easy to deal with either.
11-15-2012 09:17 PM
exv152 Initially DHG might be tricky to plant & keep down, but it will soon establish. Try tweezers and plant little bundles at a time, and don't be afraid to plant them deep enough. Give it a good month.
11-15-2012 08:11 PM
DerekFF Wow 6"? Thats the deepest i think ive ever heard of lol. I would think at 3" it shouldnt be an issue. Plant stems at an angle, say 60 degrees. Theyll still grow straight but it gives lighter soils more holding power

Sent from my DROIDX using Tapatalk 2
11-15-2012 08:00 PM
Teachercjc The substrate is roughly 3 inches at the minimum depth and 6inches + at the highest depth. I will try and post a picture.
I am looking for the carpet effect so was thinking of dwarf hair grass unless there are any other suggestions?



Posted from Plantedtank.net App for Android
11-15-2012 07:47 PM
KrazyFish you could add sand as a cap to the top layer of existing substrate. Over time it will filter down into the substrate below and fill up the spaces. Put wet sand into a cup and gently pour it out onto the substrate with the water still in the tank. Just wash/rinse the sand you use really well. No need to remove the existing substrate.
11-15-2012 07:37 PM
exv152 How thick is your layer of substrate, and what kind of plants are you planting?
11-15-2012 06:22 PM
Teachercjc
substrate not holding plants

I want to plant DHG in my 400l tank to get the carpeted look. I currently have JBL Manado substrate but I'm thinking I may need something more fine (almost like a sand) to stop the shoots floating to the top.

Since I dont really wanna take out all the substrate, is there a way of adding a thin layer of something on top to help hold the shoots?!



Posted from Plantedtank.net App for Android

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT. The time now is 10:11 AM.


Powered by vBulletin®
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright Planted Tank LLC 2012