|Topic Review (Newest First)|
|01-24-2014 12:48 AM|
|Disher||Thanks for the write up. You've saved a lot of people some money!|
|01-19-2014 09:06 AM|
|Down_Shift||wow great job on the lily. they won't crack like glass too and even if it does, you can always make another|
|01-15-2014 01:40 AM|
Decided to go with some custom acrylic work on an indoor pond I have, as well as on a small nano planted tank I am working on. So here is my first finished product (Second attempt) at an acrylic drop checker.
Basically I took a piece of acrylic tubing, heated it in the middle and slowly pulled the two pieces apart, allowing the tube to seal. Then I blew out the bubble and used salt to help the bend not deform. In the future I wouldn't use salt again, but instead heat the bend a little hotter than before, slowly make the bend while continuing to heat it, then blow the bend out gently to correct the kink.
Also as another piece of advice, the best way I have found so far to cut the piping (No cracking at all) is to use a Jeweler's Saw and a #2 blade. The blades are very fragile so you may go through a few, but they are meant to cut soft metals and have very very fine teeth, so dont run that much of a risk of cracking the acrylic.
Let me know what you think!
|09-10-2013 01:17 AM|
|Subtletanks91||So even the connector that connects the hose to the outflow won't connect to a diy lily pipe?|
|09-10-2013 12:47 AM|
Originally Posted by Subtletanks91 View Post
|09-09-2013 05:54 AM|
|Subtletanks91||This is simply amazing. After reading this I want to make my own spray bar and Lilly pipe for the fluval 405 but I have the rigid hose do you think the pipe and bar will fit snug into the grey connected on the hose?|
|03-20-2013 12:40 AM|
|GJL Creative Solutions||
Well, I've gathered all the items I need. Luckily here in San Diego we have a place called Ridout Plastics that had everything I needed! Saved me some shipping. I picked up a Exacto Razor Saw to do the cutting and a 7 in 1 Emory board for the polishing
Wish me luck
|01-23-2013 12:40 PM|
Smooth ends on lily pipes
If the tube you are using works the same as plexiglas after you cut the bulb in two and smooth the edge with sand paper, heating the raw edge will melt it slightly and it will be smooth and clear. Try it on a scrap piece. Great write up.
|01-19-2013 05:08 AM|
|CPDzeke||Try tap plastics|
|01-19-2013 04:20 AM|
i wish i could get my hands on acrylic pipe.
|01-18-2013 08:38 PM|
|jlennon||This is some great stuff. Thanx all.|
|01-18-2013 07:33 AM|
Originally Posted by shrimpNewbie View Post
Way too small to be useful for anything, but I was having fun playing with some surplus glass pipettes and a butane torch
|01-17-2013 10:33 PM|
|binbin9||I'm in awe. Has anyone converted a glass smoke pipe?|
|06-13-2012 11:45 PM|
|plamski||Yes.You just have to find something flexible to stick it inside .Or to use sand or salt.|
|05-09-2012 04:14 AM|
|shrimpNewbie||Has anyone tried to do an inch?|
|This thread has more than 15 replies. Click here to review the whole thread.|