|02-06-2014 02:48 PM|
|12-20-2013 09:29 PM|
Flourite black is the best. I don't care what anyone says! After that dust settles (and it might take awhile in a new tank) it's the most beautiful substrate ever.
The only one drawback of it (with any flourite) is that it's so fine that it's difficult to keep new plants anchored.
|12-20-2013 09:25 PM|
I'm usually too lazy to bother with repeatedly washing substrate.
I've used this method a few times, and it's always resulted in crystal clear water within a couple hours, if not right away.
I build my substrate with whatever hardscape, terraces, slopes, dirt, etc.
Then I get a spray bottle, and mist/spray the entire substrate for a bit, but not so much that the water level rises above the substrate.
Do my planting, repeatedly misting in between to keep plants moist.
then I'll put down a large filter sponge, and fill the tank (this last time around, I just added water behind a mattenfilter).
I believe the misting/spraying carries the fines down into the lower parts of the substrate, and the sponge breaks up the flow enough that they don't end up suspended in the water column.
|12-20-2013 12:06 PM|
Fill the tank slowly, and place shallow dish or bowl for the water to run into = way less clouding.
Wait one hour after filling ,and then turn on filtration.= no clouding.
|12-20-2013 09:09 AM|
|dana||looked up this oldie because I'm going crazy waiting for my sand to settle. I did a rinse, but not as much as some of you have, and desert storm hit my tank after a careful slow fill. I can't even plant, I can't see enough to plant. Way harder to deal with the the regular black.|
|12-24-2012 05:02 PM|
I've done it both ways. Rinse and no rinse. Both settled without any problems, but I still prefer to rinse because the cloud you can kick up without rinse is notable. Everything settles faster with a rinse.
I was more perplexed by strathums directions to rinse. I'll NEVER do that again.
|12-24-2012 04:23 PM|
|Edub||I mixed a bag of the black sand with Eco complete and did not rinse. It made a HUGE mess, but eventually settled out. I still hate messing with the gravel because every time I do it stirs up the cloudy crap. If I ever buy the sand again, I will definitely rinse it first.|
|12-24-2012 03:26 PM|
|gene4christ||OK let me say that I have not used this yet. Now that being said it is my understanding that what we are looking for is the stuff that will be best for the plants and still look good . With that is mind it seems to me that washing it down the drain defeats the purpose of buying it in the first place . So my thoughts is get it as wet as you can, put it in the tank, cover it with something to keep it from getting stirred up and fill slow! Remember why you bought your substrate and try to keep it as beneficial as you can . >Disclaimer just my thoughts <|
|12-19-2012 11:04 PM|
|DrakenZ||datruedave, i stumbled upon this forum thread looking for reviews on the fluorite sand, i had to register just so i could reply to you. You're a smart guy and you know exactly whats good. the "dust" as you all like to call it, is extremely fine sand particles, which the natural seperation of large and small particles would result in the extremely fine "dust" at the bottom of the tank, the medium particles in the middle and largest at the top (takes a while to settle of course). this natural seperation is beneficial to the break down of food and waste from ammonia > nitrites > nitrates. combined with a heating cable in the sand, the constant cycling of water around the breaking down waste and nutrients would result in amazing fertilizer and potential frequent water changes. i can't wait to get this sand set up with the heating cable in my 90 gallon.|
|02-14-2012 03:30 AM|
|Schneeball||Kind of strange, I mixed black sand and regular black rinsing one bag at a time in a five gallon bucket outside with a hose. Three rinses and there was not too much dust left but I poured out the bucket each rinse while the particles were still suspended. The black seemed to me to be the easiest to rinse. I've used two other colors, the regular and one other. I would never subject my drains to that dust though! All of my tanks cleared to near perfect within about 12 hours running canister filters and sponges.|
|02-13-2012 04:24 AM|
|02-12-2012 03:54 AM|
I'm not sure how the fine particles of Flourite are any more functional than the larger ones (the CEC rating applies to any sized particles) when it comes to utilization by plant roots.
While Dave's experience is certainly respectable, I suggest you do some searches on others' experiences with Flourite as well.
As for me, I've used original Flourite in one tank, which I didn't rinse, and had to clean my filter daily for two weeks to clear, to another tank with original Flourite, which i did rinse, and had a clear tank in 3 days without cleaning media, to two tanks with Black Sand Flourite, both of which I rinsed thoroughly, and had clear tanks within days without cleaning media. In any case, good luck!
|02-12-2012 03:30 AM|
|02-12-2012 03:30 AM|
Basically, I used all precautions when putting the water in. I was extremely patient with letting the filters do their work, but after 3 days and seeing almost 1/2 inch of "dust" on top of the sand. Letting it "settle" back in definitely would not have not happened
|02-10-2012 05:06 PM|
|This thread has more than 15 replies. Click here to review the whole thread.|