|02-05-2015 02:39 AM|
Equation to solve for chart.
If KH or pH is out of the ranges in chart.
|02-05-2015 01:10 AM|
|knj||once you have timed your gh and kh times that by 0.056 to get the number for the co2 chart.|
|03-18-2014 02:10 AM|
Soo... If the "appropriate" CO2 level is dictated partially by the CO3^(2-) KH level... THEN I should be able to dose baking soda again, get another degree of KH and then the levels of CO2 in the tank will be even better for my plants? I had added baking soda to my tank last week to raise the KH one degree after reading about it in Walsted's book......... Without an effect on the pH, which was my main concern...
I know someone said earlier that the CO2 produced by the fish should be negligible, but I have 10 goldfish in 100G here. I want to turn the airstone off but I am scared of oxygen deprivation, especially with my old one. Are there differences between how the fish act with oxygen deprivation and carbon dioxide overkill?
Is there a danger in raising CO2 concentrations if I don't really have the plant load, or is it more of a concentration thing rather than a total CO2 in the tank?
|03-18-2014 01:54 AM|
Dingdingding! I finally got it!
My drop checker didn't come with a full chart, just "blue is low, green is good, yellow is high" but I can use the chart that came with my API freshwater kit to get the pH of the dropchecker solution. So from the CO2 chart, I am closer to optimal CO2 than I thought (ignoring the presence of other buffers), which supports my hypothesis that I've been neglecting some other fert all this time.
DC pH = 7.2
tank KH = 5
GH = 6-7
|03-15-2014 05:14 PM|
|03-05-2014 04:32 PM|
Optimal CO2 is based on the individual aquarium in question.
A low light tanks with a shop light over it, maybe 1-2 bulbs, well, the CO2 demand is not going to be great.
A similar tank with more light that's strongly PO4 limited, will also have less CO2 demand.
A very high light tank and plenty of ferts, and also very intense plant growth, well..........you will need more CO2.
So there's no one single optima for all tanks.
For most densely planted moderate light tanks with reasonable ferts, 30 ppm is a good target to start with. But the chart may not be accurate due to the tap water treatment for SOME tap water suppliers, while it's likely okay for others.
Optimal CO2 is pretty much done by eyeballing it. Looking at the plants, growth and fish/livestock health.
You get close with measurements as best you can, then the rest is a slow progressive increase/decrease and watch closely over the next few days before deciding to add more/less etc. There's no hard no# associated with CO2 really. And it's not something you can easily measure and dial in. You need to work at it.
You need to know the signs of poor CO2, in plants, in algae and with livestock.
Unfortunately, this means experience. Which newbies and folks with issues rarely have .
|03-05-2014 03:46 PM|
I have just read this whole thread. Great information BTW!
I would like to see the article and chart but the link is broken.
It appears to me some people keep referecing the pH of their aquarium water when actually the chart is for a drop checker REFERENCE SOLUTION as others have stated. Unless of course your tank water has few or no other acids in it... Is that correct?
My QUESTION is why at the base of the chart does it say the ideal CO2 is 25ppm when most people are targeting 30ppm or even higher as Tom Barr has stated? It clearly says that anything over 25ppm is dangerous for livestock. Is this true or not?
|10-16-2013 04:56 PM|
|king kong||Interesting reading through the learning curve. Figured out my problem. That chart is the Bible. The harder the water the less CO2 it takes to get to 30 ppm. I am at 11.5 Kh according to Salifert so my range is 7.2 Ph. I was cooking my plants with CO2.|
|07-07-2012 12:09 AM|
|Ptyochromis||How would you use this chart if your PH is past 8.2? Or better yet keeping your PH at 8.2 while maintaining adequate PH. I have hard water cichlids (lake Tanganyika), but am planning on planting the tank. Is there no way to keep the KH/GH at 8-15, PH at 8.1-8.3 and still maintain decent levels of CO2 with very little swings in chemistry?|
|04-14-2012 03:10 AM|
oOKkay...This way is much clearer:
dKH = 1
dGH = 17.9
pH = 6.1
It will help if you provide more info on plants, tank size, lights, trying DIY CO2? etc.
If lights are strong enough plants' chloroplasts are able to make plant sugar/energy from carbon in solution (depending on plant requirements this translates to having preferably higher alkanity).
Floating plants are able to get their energy from carbon dioxide in air but also benefit from carbon in solution as carbonates, organic soil, etc
|12-04-2011 05:52 PM|
|finchflex||question...my ph is 6.1....and mydkh is 1...ppm gh/kh is 17.9...with out co2 injection?...my question is my tank getting co2 from elsewhere?|
|12-02-2011 03:23 PM|
Can I use my marine (salt water) kH test by API to check my planted tank kH? I don't really trust my dip strips. The strips are the only thing I have at the moment.
|11-21-2011 02:33 AM|
Check this out:
|11-13-2011 02:15 PM|
|cblwry||Here's a dumb question. If I read this thread correctly, it's better to put distilled water in my DC. Correct?? The instructions that came with the drop checker said to put in aquarium water. It is showing a lime green right now and my testing shows a PH of 6.6. I do have a little problem with brush algae but not much. And I take it that plants "pearling" is a good sign even though mine have not done that yet.|
|10-11-2011 06:51 PM|
|This thread has more than 15 replies. Click here to review the whole thread.|